Close

05/04/2020

How do you reset ducted air con?

How do you reset ducted air con?

Reset system by switching off at mains power, power down for at least 10 minutes then restart . If the unit is switched on and the circuit breaker or fuses are intact, check the isolator outside by the outdoor unit make sure this is switched on .

How do you light a pilot light on ducted heating?

Once the gas has had time to dissipate, turn the knob to “Pilot.” Then, hold down the “Reset” button and bring the flame of a long lighter close to the pilot light opening. This should light the furnace pilot light. Once you are sure the pilot light is on, release your pressure on the reset button.

How do I turn my pilot light back on?

Turn the gas regulator valve to the “pilot” position. If the water heater has a manual “ignite” button, press that to light the pilot. If it doesn’t have the button, or the button fails, press the regulator valve and hold a grill lighter or long match to the pilot light valve until the pilot ignites.

Why is my ducted heating not working?

The top reason why your ducted heater has stopped working is that the thermostat is not working well. The electricity power supply is the primary source from which the heater or furnace receives power to switch on. So, the cause of your heater not functioning may be the power supply or a tripped circuit breaker.

Where is the reset button on my air conditioning unit?

Since most window air conditioners do not have a reset button, you’ll need to unplug it for a few minutes to dissipate the charge. After plugging it back in and turning the circuit back on, the window AC unit should reset and be operational again.

What does code 65 mean on a brivis heater?

Just wondering if anyone knows what a error code #65 is. Ignore the ‘H01’ part unless you have more than one heater. Error 65 indicates that the heater controller has ‘locked out’ the main fan because a fault has been detected.

What is the brivis error code for motor lockout?

While the fan limp fault is registered and a motor open circuit occurs or an overheat cool down is initiated the motor lockout fault is flagged. Brivis Error Code 65 Motor Lockout: While the fan limp fault is registered and a motor open circuit occurs or an overheat cool down is initiated the motor lockout fault is flagged.

What should I do if I get an error code for brivis?

Below are the error codes for Brivis systems and the matching explanation. This will delete your AC’s on board memory. We recommend trying this simple trouble-shooting solution before spending money on a service call. Separate your AC system from its power supply.

What does error 50 mean on a brivis air conditioner?

Error 50 indicates that the heater has locked out after 4 ignition attempts. This error can be reset by using the reset button to restart the heater. However, the unit will probably lockout again if the condition has not been rectified. Check the gas supply is turned ON at the meter, and at the appliance gas cock.