What is DuoTrap Bluetooth on a Trek bike?

What is DuoTrap Bluetooth on a Trek bike?

Bontrager DuoTrap is the integrated sensor that wirelessly transmits ANT+ and Bluetooth® Smart signals to your computer or phone. The easy-to-use sensor installs in seconds and fits directly into the chainstay of select Trek bicycles for a clean look and preserved aerodynamics.

How do I wake up DuoTrap?

Use a strong magnet and wave it over the duotrap to see if the lights come on, if they do you found the problem. You don’t get lights the entire time with the Duotrap- only when the unit is “waking up”.

Does DuoTrap work with iPhone?

I was able to get the DuoTrap S to talk to my iPhone XS Max by pairing it first in an app called Cyclemeter. Once it is paired in Cyclemeter, it then shows up in Stava. Both Apps show the speed and cadence.

How do you reset a trek sensor?

Refer to the following steps for the operation of your sensor computer. When you are in wheel-circumference value review mode, press L or R button to select bike 1 or 2. For wheel-circumference resetting, press L & R at the same time again until the last two digits blink.

How does the Bontrager duotrap s sensor work?

Bontrager DuoTrap S is the integrated sensor that wirelessly transmits ANT+ and Bluetooth® Smart signals to your computer or phone. The easy-to-use sensor installs in seconds and fits directly into the chainstay of select Trek bicycles for a clean look and preserved aerodynamics.

How does the duotrap’s ant + sensor work?

The included DuoTrap S ANT+ sensor offers real-time speed and cadence so you can target more productive workouts and better recovery rides. Simple setup and an intuitive one-button interface get you riding faster, while features such as auto start/stop and auto light control help you take charge of your ride.

How does a Bontrager light work on a bike?

Pair it with Bontrager lights to automatically turn your daytime running lights on or off at the beginning and end of every ride. Easy to set up A streamlined initial setup process and easy ANT+ sensor pairing will get you connected and riding faster. Easy to use

How to remove duotrap’s cover from chainstay?

Remove DuoTrap S cover from chainstay. Install sensor into chainstay. While holding sensor in place, use a 2.5mm hex to tighten the 8mm long screw. NOTE: Please ensure the 2mm spacer is installed in the grommet before tightening the screw. Remove grommet and replace with gasket in #3. Remove grommet with 2mm spacer.