What is the command for clock rate?
What is the command for clock rate?
If you have only subscribed for a 64k line, then the clock rate would have been set on the DCE side of the cable using the command ‘clock rate 64000’ under the interface. To identify which end of the cable has been plugged into a Cisco router, you can also use the command “show controller”.
How do you find the clock rate?
If you’re wondering how to check your clock speed, click the Start menu (or click the Windows* key) and type “System Information.” Your CPU’s model name and clock speed will be listed under “Processor”.
Which mode the command clock rate is used?
This can be done by using the “clock rate” command, from the interface configuration mode. To find the possible clock rate values, get the command help by using a question mark after the “clock rate” from the serial interface configuration mode, as shown below.
What is clock rate on router?
The clock rate serves to synchronize the receiver on the other side of the link. Each clock pulse signals the transmission of a bit. Note that it is mainly used in lab setups.
How do I find my DTE and DCE router?
If you can see the DTE/DCE cable, you can tell by looking which router has the DCE interface connected to it – the letters “DTE” or “DCE” will either be molded into the connector itself, or if it’s an older cable there should be a little piece of tape on the cable that tells you what the interface type is.
How do I find my CPU max clock speed?
To check your processor’s clock speed:
- Launch Task Manager (Ctrl+Shift+Esc).
- Click “Performance”.
- Check the clock speed dispalyed under “Base speed”.
What is clock speed?
In a computer, clock speed refers to the number of pulses per second generated by an oscillator that sets the tempo for the processor. Clock speed is usually measured in MHz (megahertz, or millions of pulses per second) or GHz (gigahertz, or billions of pulses per second).
Why do we require clock rate in router?
The clock rate is the speed at wich the data is transfered from some sender, so the receiving side of the communication must know what this speed of data is, in order to catch the bits in the moment their are happening on the line. Hope it help you best figure out how digital networks works.
What is a clock rate used for?
In computing, the clock rate or clock speed typically refers to the frequency at which the clock generator of a processor can generate pulses, which are used to synchronize the operations of its components, and is used as an indicator of the processor’s speed.
What is clock rate and bandwidth?
When you set the clock rate for a serial interface, you are setting the speed of the interface,in other words, actual rate of data transfer. Bandwidth is the value that you allocate to the link at DTE site to help with routing decision and QOS.
How to set clock rate on Cisco router?
Clock Rate Command on CISCO Router/Switch. Command. Use. This command is used to set the clock rate on serial links. While you can configure the clock rate on both ends of the serial link, the router will only accept the command on the DCE end.
What do you do with clock rate command?
This command is used to set the clock rate on serial links. While you can configure the clock rate on both ends of the serial link, the router will only accept the command on the DCE end. Note: Clock rate sets how many bits can be sent over a given time.
How to set clock rate in interface ATM?
To configure the clock rate between a WAN interface card (WIC) and the serial communication controllers (SCCs) that are used by the WIC, use the clockrate command in interface ATM configuration mode. To disable the clock rate setting, use the no form of this command. aal2 (Optional) Specifies the ATM adaptation layer 2 (AAL2) clock rate. aal5
How to manually copy hardware clock settings into Cisco software?
To manually copy the hardware clock (calendar) settings into the software clock, use the clock read-calendar command in EXEC mode. Read calendar is disabled. This command was introduced. No modification. No modification.