How do you install a Faria Marine tachometer?

How do you install a Faria Marine tachometer?

Cut a 3-3/8” dia hole in the dash and mount the tachometer with the backclamp supplied. 6. Connect a wire to the tachometer stud marked “GND” (ground) and secure with a nut and lockwasher. Connect opposite end to the boat’s electrical ground, generally available in several locations at or near the instrument panel.

How does a Faria speedometer work?

Electronic Type. Electronic speedometers operate by capturing pulses produced by a sensor. the pulses are then electronically converted to a speed reading very much like a tachometer converts ignition pulses to RPM.

How do you wire a marine fuel gauge?

Wiring a fuel gauge is much the same as wiring any other gauge on your boat: one wire comes from the ignition to the instrument, one wire comes from the sensor to the instrument, one wire comes to the instrument light and one wire from the instrument goes to the boat’s common ground.

What do I need to install a tachometer?

Use a wiring kit to connect the tachometer to the plug-in connector on the remote control or accessory electrical cable. Use Plug-In Connector Kit P/N 0174732 when installing tachometer only.

How do you wire a boat tachometer to a boat?

Slip one of the ring connectors on the green wire onto the terminal post on the back of the tachometer marked “GND.” Remove one of the screws on the boat’s common ground, slip the connector on the other end of the black wire over that screw and thread the screw back into the common ground, tightening the screw with a screwdriver.

How to install a tachometer on an OMC Sea Drive?

1978 and Newer Outboard and OMC Sea Drive Use a wiring kit to connect the tachometer to the plug-in connector on the remote control or accessory electrical cable. Use Plug-In Connector Kit P/N 0174732 when installing tachometer only. Use Plug-In/Fuse Block Kit P/N 0173611 when installing tachometer with other accessories.

Where to mount a flush mount alternator tachometer?

This flush mount, alternator tachometer is designed for use on the following: Disconnect battery cables to help prevent arcing or damage to equipment. Select a tachometer mounting location that is in full view of the operator. Drill a 3-3/8 in. (86mm) hole in the dashboard.